Difference between revisions of "PAS Experiment Lead Shielding"
Jump to navigation
Jump to search
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| + | == Lead Bricks == | ||
| + | |||
5/11/21 | 5/11/21 | ||
| Line 8: | Line 10: | ||
[[File:PAS_Painted_Lead_Bricks_2.jpg|300px|thumb|center|Half of the first set of painted lead bricks on cardboard drying surface.]] | [[File:PAS_Painted_Lead_Bricks_2.jpg|300px|thumb|center|Half of the first set of painted lead bricks on cardboard drying surface.]] | ||
| + | |||
| + | |||
| + | |||
| + | == Lead Sheet == | ||
| + | |||
| + | 5/17/21 - 5/18/21 | ||
| + | |||
| + | Sheared a lead sheet into 6 rough 3"x3" squares to be used for attenuation measurements with NaI detectors | ||
| + | |||
| + | Lead pieces were wiped down with a wet wipe, duct taped, rewiped, and hammered flat. | ||
| + | |||
| + | Thickness of the lead pieces is around 0.055". | ||
| + | |||
| + | |||
| + | [[File:PAS_Lead_Sheet_Full_Bare.jpg|300px|thumb|left|Half of the first set of painted lead bricks on cardboard drying surface.]] | ||
| + | |||
| + | |||
| + | [[File:PAS_Lead_Sheet_Edge_Bare.jpg|300px|thumb|center|Half of the first set of painted lead bricks on cardboard drying surface.]] | ||
| + | |||
| + | |||
| + | [[File:PAS_Lead_Sheet_Full_Taped.jpg|300px|thumb|left|Half of the first set of painted lead bricks on cardboard drying surface.]] | ||
| + | |||
| + | |||
| + | [[File:PAS_Lead_Sheet_Edge_Taped.jpg|300px|thumb|center|Half of the first set of painted lead bricks on cardboard drying surface.]] | ||
| + | |||
---- | ---- | ||
[[PAS_Shielding]] | [[PAS_Shielding]] | ||
Latest revision as of 23:44, 1 June 2021
Lead Bricks
5/11/21
Painted half size lead bricks (1"x2"x4") with red epoxy based paint for safer handling when building shielding arrays. Made the mistake of letting them dry on porous surface and now have to find way to remove cardboard that is sealed to the last unpainted side of bricks.
Lead Sheet
5/17/21 - 5/18/21
Sheared a lead sheet into 6 rough 3"x3" squares to be used for attenuation measurements with NaI detectors
Lead pieces were wiped down with a wet wipe, duct taped, rewiped, and hammered flat.
Thickness of the lead pieces is around 0.055".
