Difference between revisions of "Detector Operation and DAQ Setup"

From New IAC Wiki
Jump to navigation Jump to search
Line 11: Line 11:
  
 
= Data Acquisition (DAQ)=
 
= Data Acquisition (DAQ)=
 +
 +
==Using CAEN V792 QDC==
 +
  
 
[[Image:QDC_flow_chart.png | 100 px]]  
 
[[Image:QDC_flow_chart.png | 100 px]]  

Revision as of 13:30, 1 July 2013

Detector operation

Operating the detector occurs by providing voltage to the HV-circuit connected to the detector components mentioned in the previous section. A CAEN N470 four channel power supply is used for this purpose, using a channel of the power supply allow to increase the voltage difference between the top and bottom side of the first GEM preamplifier reaches up to 350 V then it decreases for the third GEM preamplifier, as the circuit board is provided with a voltage of 2.8 kV.

Another channel of the power supply is used to increase the voltage of the Cathode. When the cathode voltage is 3.1 kV, it will create a drift voltage up to 300V.


Abdel GEM HV distrib 6-19-09.png

The power supply is connected to a discharge protection circuit. CAEN N470 has a signal Lemo 00 input to activate a kill option automatically when a discharge signal occurs through the detector operation, the kill input is connected to the detector readout plate output, as a discharge happens and it is wider than 15 us, kill option state turns true, so it will trip all the power supply channels.

Data Acquisition (DAQ)

Using CAEN V792 QDC

QDC flow chart.png


Go Back [1]