Difference between revisions of "Gumstix Installation"

Latest revision as of 05:06, 8 December 2012

The serial connection with Gumstix can be established through the C-kermit or minicom. You can find instructions on the following web pageserial.

Correct alignment of the TTL RS232 adapter

Make sure that the TTL RS232 adapter is connected correctly and red(shows that gumstix is connected) and yellow(serial cable) lights are On.

Connecting to the gum adapter(i2c board)

On Gumstix:

Gum adapter([math]V_{cc}[/math] && [math]V_{ground}[/math]) should be connected to the voltage supply(~2.5 Volts).

From Gum adapter using network cable establish connection with BreakOut box.

@@ Line 6: / Line 6: @@
 Make sure that the TTL RS232 adapter is connected correctly and red(shows that gumstix is connected) and yellow(serial cable) lights are '''On'''.
-Gumstix username: root<br>
-Password:c0d/\2.0
 ;<math>I^2C</math> Connection
-Connecting to the little board(i2c board)
+Connecting to the gum adapter(i2c board)
 {| border="1"  |cellpadding="20" cellspacing="0
@@ Line 30: / Line 28: @@
 [[File:BreakOutGumstix_5.jpg|200px]]
+;Voltage supply
+{| border="1"  |cellpadding="20" cellspacing="0
+|-
+| Gum adapter || Voltage supply
+|-
+| <math>V_{cc}</math> || <math>out^+</math>
+|-
+| <math>V_{ground}</math>|| <math>out^-</math>
+|}
+Gum adapter(<math>V_{cc}</math> && <math>V_{ground}</math>) should be connected to the voltage supply(~2.5 Volts).
+;BreakOut Box
+From Gum adapter using network cable establish connection with BreakOut box.
+[http://wiki.iac.isu.edu/index.php/User_talk:Didbtama Go Back]