Difference between revisions of "Forest DigiKey Order"
| Line 1: | Line 1: | ||
| + | =Sept. 2011= | ||
| + | |||
| + | |||
| + | SHV connectors | ||
| + | |||
| + | |||
| + | TTL switchs | ||
| + | |||
| + | |||
| + | lemo cables | ||
| + | |||
| + | |||
=Aug 1 2010= | =Aug 1 2010= | ||
Revision as of 22:04, 14 September 2011
Sept. 2011
SHV connectors
TTL switchs
lemo cables
Aug 1 2010
- 568-1855-1-ND I2C switch 7-8 of these would be nice
- 2-position housing ~10 would be nice
- 4-position housing ~20 should be enough
- crimp-on socket minimum order 100, which should fill the connectors above
2 , 100 foot shielded ribbon cables for segmented FC ADC. (< $600) For Dan AFCI
2, 6 foot shielded connectors.
Alternate socket:
- crimp on socket available in orders of less than 100
For the LDVS repeater board:
DIgiKey Part # Description Quantity
WM1864-ND Molex Power Connector 10
609-1771-ND 34-pin Right Angle Connectors 10
296-2344-5-ND SN65LVDS104D 50
576-1172-ND 3.3V Fixed Voltage Regulator 10
493-2344-1-ND 22uF Cap for Output Voltage Regulator 10
478-5034-1-ND 1uF Cap for Input Voltage Regulator 10
750-101-R270K-ND 270K Ohm Resistor networks 24
541-100ECT-ND 100 Ohm Termination Resistors 30
478-1308-1-ND 22pF Caps for filters 200
RMCF0805ZT0R00CT-ND 0 Ohm resistors for jumpers >384
3M9580-ND Shunt Jumpers 200
old stuff
3*: 296-13109-5-ND IC REMOTE I/O EXPANDER 16-DIP These will be exposed to radiation and we may need spares
50: 27QBK-ND RES 27 OHM 1/4W 5% CARBON FILM
20: 470KQBK-ND RES 470K OHM 1/4W 5% CARBON FILM
3: 568-1855-1-ND IC I2C MUX 2CH 14-SOIC This should allow one one gumstix to control 2 breakout boards so I'd like to get a few to play with to see if they work
2*: 563-1053-ND SWITCH ROTARY DIP 8-POS TOP We'll need 14 of these eventually, but I'd like a couple to play with now