Difference between revisions of "Lab 3 TF EIM"
Jump to navigation
Jump to search
Line 36: | Line 36: | ||
=phase shift (10 pnts)= | =phase shift (10 pnts)= | ||
− | #measure the phase shift between <math>V_{in}</math> and <math>V_{out}</math> | + | #measure the phase shift between <math>V_{in}</math> and <math>V_{out}</math> as a function of frequency <math>\nu</math>. |
=Questions= | =Questions= |
Revision as of 06:14, 21 January 2011
- RC Low-pass filter
1-50 kHz filter (20 pnts)
1.) Design a low-pass RC filter with a break point between 1-50 kHz. The break point is the frequency at which the filter starts to attenuate the AC signal. For a Low pass filter, AC signals with a frequency above 1-50 kHz will start to be attenuated (not passed).
2.)Now construct the circuit using a non-polar capacitor.
3.)use a sinusoidal variable frequency oscillator to provide an input voltage to your filter.
4.)Measure the input and output voltages for at least 8 different frequencies which span the frequency range from 1 Hz to 1 MHz.
Hz | Volts | Volts | |
5.) Graph the
-vs-phase shift (10 pnts)
- measure the phase shift between and as a function of frequency .
Questions
- compare the theoretical and experimentally measured break frequencies. (5 pnts)
- Calculate and expression for as a function of , , and . The Gain is defined as the ratio of to .(5 pnts)
- Sketch the phasor diagram for , , , and . Put the current along the real voltage axis. (30 pnts)
- Compare the theoretical and experimental value for the phase shift . (5 pnts)
- what is the phase shift for a DC input and a very-high frequency input?(5 pnts)
- calculate and expression for the phase shift as a function of , , and graph -vs . (20 pnts)