Difference between revisions of "CAEN V1495 IO"
| Line 55: | Line 55: | ||
|SW 8 || 1 | |SW 8 || 1 | ||
|} | |} | ||
| + | |||
| + | |||
| + | == probing memory== | ||
= Download Firmware= | = Download Firmware= | ||
Revision as of 16:34, 5 May 2009
Manual
Media:CAEN_V1495_Manual_Rev6.pdf
Readout code
V1
The ZIP file below contains the HDL source code to download into the V1495
http://www.physics.isu.edu/~tforest/DAQ/GEMReadout_V1495Source_Rev1_0.zip
The ZIP file below contains the ROC library
http://www.physics.isu.edu/~tforest/DAQ/GEMReadout_VxWorkxSource_11_26_2008.zip
ROC lib
compile library
To compile the ROC library I executed the following command within the subdirectory containing the v1495.c file
ccppc -fno-builtin -fno-for-scope -fstrength-reduce -mlongcall -mcpu=604 -DCPU=PPC604 -DVXWORKS -D_GNU_TOOL -DVXWORKSPPC -I/usr/local/coda/2.5/common/include/ -I../h -c -o v1495Lib.o -i v1495.c
load library onto the ROC
I then copies the library v1495Lib.o into my ROC library subdirectory which is where the ROC is pooing at boot up
/home/daq/CODA/ROClibs/libs
I loaded the library by hand by typing the following at the ROC console
-> ld < v1495Lib.o value = 268430512 = 0xfffecb0
Setting address
The address pins on this module are not labeled so I adopted the convention of numbering them from left to right as I look from the front pannel.
| Address | |
| Pin | Setting |
| SW 3 | 3 |
| SW 4 | 2 |
| SW 7 | 1 |
| SW 8 | 1 |
probing memory
Download Firmware
v1495firmware(0xfa510000,"GEMReadout.rbf",0,0)
Go back VME_modules Go back