Difference between revisions of "First Board for Beam Profile"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
| − | + | [[File:Board_1.JPG|400px|thumb|left|Board is separated into two inch squares with mounts for an OSL at each intersection, allowing for a total of 169 OSLs to be fitted per run]] | |
| + | |||
| + | [[File:Board_1_close_up.jpg|400px|thumb|center|Close up of the mounting nails and center of the board. Nails are positioned such that the center of the OSL is on the intersection, allowing for easy symmetry]] | ||
| − | |||
[[File:Holes_drilled.JPG|400px|thumb|left|Holes are drilled into the board to allow dose sticks to be attached to the back of the board]] | [[File:Holes_drilled.JPG|400px|thumb|left|Holes are drilled into the board to allow dose sticks to be attached to the back of the board]] | ||
| − | |||
[[File:96cm_First_Run_OSLs_Loaded.JPG|400px|thumb|center|OSLs loaded for the first run to determine beam profile]] | [[File:96cm_First_Run_OSLs_Loaded.JPG|400px|thumb|center|OSLs loaded for the first run to determine beam profile]] | ||
| + | [[File:Measured_Distance_from_Beam_End.JPG|400px|thumb|left|Distance from the beam end to the board]] | ||
| + | [[File:Fully_Loaded_Array_for_50cm_Shot.JPG|400px|thumb|center|Board fully loaded and prepared to be mounted in front of accelerator]] | ||
| − | + | [[File:Mounted_Array_for_50cm_Shot.JPG|400px|thumb|left|Fully loaded array at 50cm. Full array holds 191 OSLs]] | |
| − | |||
| − | |||
| − | |||
Revision as of 04:49, 2 August 2016
