TF NEAMS-2 - Revision history

Foretony at 01:59, 5 July 2019

2019-07-05T01:59:02Z

2019-07-05T01:50:37Z

2019-07-04T23:38:59Z

2019-07-04T23:36:04Z

2019-07-04T23:35:24Z

New page

[[User_talk:Foretony#TF_NEAMS-2]]

[[User_talk:Foretony#TF_NEAMS-2]]

← Older revision		Revision as of 01:59, 5 July 2019
Line 12:		Line 12:
	, A.G.EvansR.W.Davidge, Journal of Nuclear Materials Volume 33, Issue 3, December 1969, Pages 249-260		, A.G.EvansR.W.Davidge, Journal of Nuclear Materials Volume 33, Issue 3, December 1969, Pages 249-260

		+	= In Situ material radiation damage measurement=
		+
		+	Using a positron beam one can monitor the surface damage produced by an ion beam on a material.
		+
		+	Using photon induced positron annihilation you can adjust the penetration depth of the photon to scan the bulk material more. This would allow you to measure neutron damage as it occurs using MeV energy photons. By changing the energy of the photon you change the depth of the probes measurement.

	=References=		=References=

← Older revision		Revision as of 01:50, 5 July 2019
Line 8:		Line 8:
	Use a 2 MeV Xenon beam to irradiate a diving board that is machined out of 2 mm UO2 pins from INL.		Use a 2 MeV Xenon beam to irradiate a diving board that is machined out of 2 mm UO2 pins from INL.

−		+	1.) An arcticle that measured how the strength of UO2 changes with temperature and grain size.
		+	The strength and fracture of stoichiometric polycrystalline UO2
		+	, A.G.EvansR.W.Davidge, Journal of Nuclear Materials Volume 33, Issue 3, December 1969, Pages 249-260

@@ Line 1: / Line 1: @@
 [[User_talk:Foretony#TF_NEAMS-2]]
-NEAMS
+NEAMS-2
 Use 2 MeV protons to irradiate zirconium to study the temperature dependence of the initial recombination.  The incident proton causes surface damage on the zirconium during the ballistic phase knout out.  Recombination occurs afterwards and can be temperature dependent.

← Older revision		Revision as of 23:36, 4 July 2019
Line 1:		Line 1:
	[[User_talk:Foretony#TF_NEAMS-2]]		[[User_talk:Foretony#TF_NEAMS-2]]
		+	NEAMS

		+	Use 2 MeV protons to irradiate zirconium to study the temperature dependence of the initial recombination. The incident proton causes surface damage on the zirconium during the ballistic phase knout out. Recombination occurs afterwards and can be temperature dependent.
		+
		+	2.6 MeV proton irradiation effects on the surface integrity of depleted UO2 (effects seen after 10^{17} protons/cm^2 )
		+	https://www.sciencedirect.com/science/article/pii/S0168583X1301152X
		+
		+	[[Media:Zr-Alpha_IradDamageSimul_O_Trachenko_2001.pdf]]
		+
		+	[[Media:Zr-IrradDamage_Zarkadoula_2014.pdf]]
		+
		+	article on silicon damage from ions
		+
		+	https://www.sciencedirect.com/science/article/pii/S0168583X14002183
		+
		+
		+	measuring ion damage to UO2 using Raman scattering
		+
		+	Appl. Phys. Lett. 100, 251914 (2012); https://doi.org/10.1063/1.4729588 [[File:Guijmbretiere_APL_2012.pdf]]
		+
		+	====Atom Probe Tomography ====
		+
		+	Atom Probe Tomography used to study Uranium oxide
		+
		+	Valderrama, B. et al. Investigation of material property influenced stoichiometric deviations as evidenced during UV laser-assisted atom probe tomography in fluorite oxides. Nucl. Instruments Methods Phys. Res. Sect. B Beam Interact. with Mater. Atoms 359, 107–114 (2015).

	[[User_talk:Foretony#TF_NEAMS-2]]		[[User_talk:Foretony#TF_NEAMS-2]]